GIET-VM / CMA Driver

The cma_driver.c​ and cma_driver.h​ files define the CMA driver.

It supports the SOCLIB vci_chbuf_dma component, that is a multi channels, chained buffer DMA controller. This component can be used in conjonction with the SOCLIB vci_frame_buffer to display images, or with the SOCLIB vci_multi_nic controller to transfer RX or TX packets between NIC buffers and memory buffers.

A single CMA channel transfers continuously data from an infinite stream of buffers (source chbuf) to another infinite stream of buffers (destination chbuf). A chbuf descriptor is a variable size circular array of 64 bits entries. Each entry is a single buffer descriptor, and contains a 48 bits physical address (PADDR) and a valid bit V that is 0 when the buffer is empty.

1	15	48
V	unused	------- PADDR ---------

The SEG_CMA_BASE address must be defined in the hard_config.h file.

The addressable registers map is defined here​.

Access Functions

unsigned int _cma_get_register( unsigned int channel, unsigned int index )

This low_level function returns the value contained in register (index).

void _cma_set_register( unsigned int channel, unsigned int index, unsigned int value )

This low_level function returns the value contained in register (index).

void _cma_channel_start( unsigned int channel, unsigned long long src_paddr, unsigned int src_nbufs, unsigned long long dst_paddr, unsigned int dst_nbufs, unsigned int buf_length )

This function activates a chained buffer DMA channel.

• channel : CMA channel index.
• src_paddr : physical address of the source chbuf.
• src_nbufs : number of buffers in the source chbuf.
• dst_paddr : physical address of the destination chbuf.
• dst_nbufs : number of buffers in the destination chbuf.
• buf_length : single buffer length (bytes)

void _cma_channel_stop( unsigned int channel )

This function desactivates a chained buffer DMA channel.

• channel : CMA channel index.

Interrupt Service Routine

void _cma_isr( unsigned int irq_type, unsigned int irq_id, unsigned int channel )

A CMA IRQ is activated in case of memory access error for a specific CMA channel:

• SRC_DESC_ERROR : error accessing source chbuf descriptor
• SRC_DATA_ERROR : error accessing source data buffer
• DST_DESC_ERROR : error accessing destination chbuf descriptor
• DST_DATA_ERROR : error accessing destination data buffer

The Interrupt Service Routine displays a message on TTY0 and desactivates the CMA channel to acknowledge IRQ.