source: trunk/softs/tests_cc_vcache/test_excep_intr/test.S @ 1024

/*
 * Check interrupt while in trap handler.
 * Cache is enabled so we have one instruction/cycle
 */
#include <registers.h>
#include <misc.h>
#include <vcache.h>
#include <xicu.h>

#define DOLOAD_ADDR 0x80000000

        .text
        .globl  _start
_start:
        .set noreorder
        la      k0, TTY_BASE
        la      k1, EXIT_BASE
        la      sp, 0x00200000 - 16

        /* reset cause, make sure IV is off */
        mtc0    zero, COP0_CAUSE

        la      a0, pte1
        srl     a0, a0, 13
        mtc2    a0, VC_PTPR
        nop
        nop

        li      a0, VC_TLB_EN_ITLB | VC_TLB_EN_DTLB | VC_TLB_EN_ICACHE | VC_TLB_EN_DCACHE
        mtc2    a0, VC_TLB_EN

        PRINT(startstr)

        /* program xicu */
        la      t0, XICU_BASE
        /* clear pending interrupt */
        lw      a0, XICU_PTI_ACK(0)(t0)
        /* route PTI0 to irq 0 */
        li      a0, 1 << 0
        sw      a0, XICU_MSK_PTI_E(0)(t0)
        /* init s0 */
        li      s0, MAGIC2
        /*
         * interrupt in INTERRUPT_DELAY cycles.
         */
        li      a0, INTERRUPT_DELAY
        sw      a0, XICU_PTI_PER(0)(t0)
        /* clear pending interrupt */
        lw      a0, XICU_PTI_ACK(0)(t0)
        /* reset cop0 status (keep BEV), enable interrupt 0 */
        lui     a0, 0x0040;
        addiu   a0, 0x0401;
        mtc0    a0, COP0_STATUS
        nop
        nop
        nop
        nop
        nop

        nop
        move    a1, zero
        la      s0, DOLOAD_ADDR
        jalr    s0
        nop
        j       end
        nop
        /* we should not end there */
        EXIT(1)

end:
        PRINT(endstr)
        move    a0, a1
        PRINTX
        PUTCHAR(' ')
        la      a0, myvar
        lw      a0, 0(a0)
        PRINTX
        PUTCHAR('\n')
        EXIT(0)

        .globl excep
excep:
        .set noreorder
        /* don't clobber a0 and ra */
        addiu   sp, sp, -8
        sw      a0, 4(sp)
        sw      ra, 8(sp)

        PRINT(statusstr)
        mfc0    a0, COP0_STATUS
        PRINTX

        PRINT(causestr)
        mfc0    a0, COP0_CAUSE
        move    s0, a0
        PRINTX

        PRINT(pcstr)
        mfc0    a0, COP0_EXPC
        PRINTX

        PRINT(badvastr)
        mfc0    a0, COP_0_BADVADDR
        PRINTX

        PRINT(xicustr)
        la      t0, XICU_BASE
        lw      a0, XICU_PRIO(0)(t0)
        PRINTX
        PUTCHAR('\n')
        /* map VA DOLOAD_ADDR at PA 0xbfc01000 */
        la      t0, pte22 + VADDR_TO_PTE2I(DOLOAD_ADDR) * 8
        la      a0, (0xbfc01000 >> PTE2_SHIFT)
        sw      a0, 4(t0)
        la      a0, (PTE2_V | PTE2_C | PTE2_X)
        sw      a0, 0(t0)
        mtc2    zero, VC_DCACHE_FLUSH /* flush the whole data cache */

        andi    a0, s0, 0xff00
        beq     a0, zero, notintr
        nop

        /* disable timer0 */
        la      t0, XICU_BASE
        sw      zero, XICU_PTI_PER(0)(t0)
notintr:
        la      a1, myvar
        la      a0, 0(a1)
        beq     a0, zero, noex
        nop
        EXIT(2)
noex:
        li      a0, 1
        sw      a0, 0(a1)
        lw      a0, 4(sp)
        lw      ra, 8(sp)
        addiu   sp, sp, 8
        eret
        /* we should not end there */
        EXIT(1)

        .rodata:
statusstr: .ascii "status \0"
causestr: .ascii " cause \0"
pcstr: .ascii " pc \0"
badvastr: .ascii " badva \0"
xicustr: .ascii " xicu \0"
startstr: .ascii "start\n\0"
endstr: .ascii "end \0"

        .org EXCEP_ADDRESS - BOOT_ADDRESS
        .globl evect
evect:
        j       excep
        nop
        /*
         * we use a ldscript trick here, to load this function at
         * the appropriate address
         */
        .section .text2, "ax"
        .globl doload
doload:
        la      s0, testval
        jr      ra
        lw      a1, 0(s0) /* this should trigger the exception */
        /* we should not get there */
        EXIT(1)
        nop
        .data
myvar:  .word 0
testval:
        .word MAGIC2
        .globl pte2
pte2:
        .align 12
        .word PTE2_V | PTE2_C | PTE2_X
        .word BOOT_ADDRESS >> 12
        .org pte2 + 4092
        .globl pte22
pte22:
        .align 12
        .word 0
        .word 0
        .org pte22 + 4092
        .globl pte1
pte1:
        .align 13
        .word PTE1_V | PTE1_C | PTE1_W | 0x0 /* map PA 0 at VA 0 */
        .org pte1 + (DOLOAD_ADDR >> 21) * 4
        .word PTE1_V | PTE1_T | (0x2000 >> 12) /* map VA DOLOAD_ADDR with 4k page: check real address of PTE22 !!! */
        .org pte1 + (BOOT_ADDRESS >> 21) * 4
        .word PTE1_V | PTE1_T | (0x1000 >> 12) /* map PA 0xbfc00000 at VA 0xbfc00000 with 4k page: check real address of PTE2 !!! */
        .org pte1 + (TTY_BASE >> 21) * 4
        .word PTE1_V | PTE1_W | (TTY_BASE >> 21) /* map PA 0xd0200000 at VA 0xd0200000 */
        .org pte1 + (XICU_BASE >> 21) * 4
        .word PTE1_V | PTE1_W | (XICU_BASE >> 21) /* map PA 0xd2000000 at VA 0xd2000000 */
        .org pte1 + (EXIT_BASE >> 21) * 4
        .word PTE1_V | PTE1_W | (EXIT_BASE >> 21) /* map PA 0xe0000000 at VA 0xe0000000 */
        .org pte1 + 8192
        .word 0